Testing and maintenance of cement foaming machines

Testing and maintenance of cement foaming machines

Cement foam machines are widely applied in our manufacturing and living, but many people do not pay attention to the detection and maintenance of machines, also do not tell much about the knowledge and maintenance of knowledge, let's concentrate on these knowledge details.1. Check the hydraulic material of the cement foaming machine.

Due to the complexity of equipment, we recommend that experts conduct inspection and treatment of hydraulic systems with experience.

If the fault is found, check before an operation and repair the entire loop.

- Oil is retrieved and the reasons for leak are doped.

- Safety valve, hydraulic system, check the steel pipe and hose, accessories, oil cylinder, and any wear and crack (pipe explosion can have very serious consequences)

- Check the pipeline from the relief valve from the cylinder entrance so that no external discharge or vomiting is confirmed due to the impact and wear and the integrity of the goods is ensured.

Immediately replace any damaged tubes.

- Do not change original settings;

All coordination and calibration can be done only by professionals.

It is strictly prohibited in the use of hydraulic components, otherwise the manufacturer will not be liable for warranty and liability for the product.Δ Alert

- Due to the high temperature of the hydraulic oil, there are risks of thorns, so proper protective measures should be taken before opening part of the pipeline connection.

- Any replacement parts must be consistent with the level specified by the manufacturer.

2. Lubrication inspection of cement foaming machines.

Lubrication should always be sufficient and clear in Greece, and lubrication pipes will not overflow over joints.

Watch the oiliness of the operating parts at any time.

Please check immediately to prevent accidents due to lack of oil.

Lubricating oil in the reducer should be kept in the designated position.

Check the amount of oily oil in length air compressor and lubrication oil is special lubrication oil for air compressor.

Apply grease to the mechanical structure to prevent surface exposure.

The lasting equipment should be fully lubricated for all components.

Δ Alert

Before lubrication, clear oiled oil face to prevent foreign impurities from disrupting shampoo and shafts.

Oily parts are completely filled with new fats and may be lubricated well.

3,

It is often necessary to check the bonding bolt joints:

- Pull cylinder body, piece bolts and nuts.

- Cylinder joint and frame bolts connection.

- The connecting point at both ends of the main cylinder.

- oil pump suction port, outlet and pipe pair bolts.

- Protestant holder bolt

- Correction Bowl for oil pump and pump seat, pump seat and floor, oil motor and support.

- Converging pipe collar nuts

4. Inspection and treatment of leakage parts of cement foaming machine.

The main leak detection parts are: surface gear, oil drain plug, oil pump and oil motor shaft and shell joint surface, oil cylinder head junction flat, part cylinder handle surface and regulatory parts with piston drilling and a combination of parts and hydraulic valves, pipe joints , Oil cylinders.

Upon introduction, we learned how cement foam machines can be tested and maintained, the top role can help you, at the same time you can expect the machine to use the foaming machine for regular testing and maintenance.

Our company is welcome to ask the interested friends to produce and sell cement foam machines.